Categories
125mm (37)
150mm (36)

No7 EPDM Masterflash 152-280mm (6 to 11 inch) - Low Temp
 

Other Customers Also Purchased

Standard Fixing Kit
ONE kit is required for No.3, No.4, No.5 and No.6, TWO kits required for No.7 and No.8, THREE kits ...

Availability:  In Stock
Quantity:

Description Details Dimensions Guides
Suitable for profiled sheeting and flat panel surfaces with external pipe diameters of (6 to 11 inch) / 152 to 280mm.

APPLICATION
Suitable for profiled sheeting and flat panel surfaces and is temperature resistance -55°C to 135°C.

CONSTRUCTION
Made of EPDM, these flashings are componded specifically for maximum resistance to weathering due to ozone and ultraviolet light.
Fast, one piece construction allows for easy on-site installation in usually 5 minutes.
The base is designed to form a seal on most panel configurations and roof pitches regardless of pipe location.

INSTALLATION
1. Choose pipe opening and trim using a stanley knife or scissors.
2. Slide flashing over pipe (you may need to lubricate the flashing with some grease).
3. Form the flashing to the same profile as the roof.
4. Apply sealant (contained in the Fixing Kit).
5. Fasten using the screws and caps (supplied in the Fixing Kit).

TWO Standard Fixing Kits are required to install this flashing.

SKU FLA-LT-701
Item No7 EPDM Masterflash 152-280mm (6 to 11 inch) - Low Temp
Base Size Dia.: 355 x 355mm
Pipe External: 114-292mm
Roof Pitch: 0-45º
Temperature: 135º C
Fixing Kit